Statuses of the LEDs

PARROT SKYCONTROLLER 2

 

Flashing red

Parrot Skycontroller 2 is trying to connect to a drone.

> Make sure your drone is on.

Or

 

The battery charge of Parrot Skycontroller 2 or the drone is low.

> Recharge the battery.

Or

 

Parrot Skycontroller 2 has detected a problem with the drone.

> Go to the Support section at www.parrot.com

Solid green

Parrot Skycontroller 2 is connected to the drone.

> You can fly the drone.

 

PARROT BLUEGRASS

 

Flashing blue

Parrot Bluegrass has detected the GPS signal and is ready to take off.

Flashing green

Parrot Bluegrass is in flight.

Flashing yellow

Parrot Bluegrass is updating. Do not switch off Parrot Bluegrass.

Flashing red and blue

Parrot Bluegrass has detected a problem with the battery. > Contact your dealer or go to the Parrot Bluegrass support page at www.parrot.com.

Flashing red

Parrot Bluegrass has detected an error. > An error message appears on the FreeFlight Pro app. Go to the error code table available on the Parrot Bluegrass support page.

 

WARNING LIGHT

INDICATIONS

PARROT SEQUOIA+

For more information on the settings of

Parrot Sequoia+, download the Parrot Sequoia+ user guide

Available at Parrot.com.

 

General

Quickly flashing orange

Shutting down

Slowly flashing orange

Update in progress

Flashing blue

Enabling/disabling Wi-Fi

 

Problem

Solid red

Hardware malfunction

Flashing red

Corrupted memory. Repair in progress. When the repair is complete, the LED turns green again. This may take several seconds depending on the available space on your SD.

Flashing yellow

Full memory

 

Calibration of the magnetometer

Solid purple

The sensor must be stationary for 1 second.

Flashing purple

The sensor must be calibrated.

Flashing green

Calibration in progress (pitch)

Flashing cyan

Calibration in progress (roll)

 

Photo/video

Solid blue

Capture in progress

Solid light green

At least one of the four sensors is enabled

Flashing light green

The files are being written

 

SUNSHINE SENSOR

 

Problem

Solid red

Hardware malfunction

Flashing yellow

SD card full

 

Calibration of the magnetometer

Solid purple

The sensor must be stationary for 1 second.

Flashing purple

The sensor must be calibrated.

Flashing green

Calibration in progress (pitch)

Flashing cyan

Calibration in progress (roll)











Update : 26/02/2019
Cet article vous a aidé ?

 



 

Chat now retract