If your Parrot Rhythm n'Blue has been installed by a professional, go directly to Using Standard Features.
Content of the kit
The Bluetooth car radio
Fitting accessories
Connecting wires
Manual
External Microphone
Installation of the car radio:
Before starting any installation please ensure that the battery has been disconnected in line with vehicle
guidlines. Ensure that all codes required for reconnection of the battery are avaible (alarm, etc).
Note:
Before finally installing the Rhythm n'Blue, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly.
The use of unautorized parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
Install the unit where it does not get in the driver's way cannot injure the passenger if there is a sudden stop, like an emergency stop.
The installation angle must not exceeds 30° from horizontal.
Installation of the unit:
After inserting the half-sleeve into the correct position, bend the appropriate tab according to the thickness of the dashboard material in order to secure the holder in place.
Once done insert the car radio into the holder.
Removing the unit:
Insert the levers (include into the packaging) into the groovers at both sides of the product.
Listen for the "click".
Pulling the levers makes possible to remove the unit from the holder.
Installation Diagram:
Note: Installation of the power supply cable:
The red wire of the power cable must be connected to the permanent 12V, the orange wire to the 12V and the black
wire to the earth.
Verify the electric wiring of the ISO supply bundle of the in-car radio.
In some vehicles, it is necessary to reverse the positions of the red and orange wires.
This operation is simply done by reversing the fuse holders.
Do not connect the orange wire to the permanent 12V, otherwise you risk causing the vehicle batterie to go flat.
